Xitomer Motorcycle Fender Eliminator Fit for CFMOTO 675 SR, SR-R 2024-2026

Keeping All Road-Legal Lighting Intact Fitment: Compatible with CFMOTO 675 SR 2024-2026 Compatible with CFMOTO 675 SR-R 2024-2026 Compatible with CFMOTO 675 SS 2024-2026 Compatible with CFMOTO 675 NK 2025-2026 What This Kit Does The bracket bolts right onto the factory subframe mounting points, pulling the license plate and lights up under the tail where they belong. An integrated LED unit combines brake light, running light, and license plate illumination into one compact assembly — red for brake, green for running, black for ground. Dedicated turn signal brackets are pre-drilled for aftermarket signals. Wiring: Not Plug-and-Play, But Doable The tail light requires cutting and splicing three wires into the bike’s harness. We supply heat-shrink tubing to seal each connection against water and corrosion. The included manual walks you through the process: slide the tubing on first, join the wires, position the tubing over the joint, heat to seal. A clean, professional result is achievable with basic electrical tools and a little patience. What’s in the Box: Fender eliminator bracket ×1 Tail light ×1 Stainless steel mounting hardware set ×1 Heat shrink tubes ×1 set Installation instruction ×1

Fit for CFMOTO 675 SS 2024-2026, CFMOTO 675 NK 2025-2026, Tail Tidy License Plate Holder Tail Light, fit aftermarket signals

Fitment: Compatible with CFMOTO 675 SR 2024-2026, CFMOTO 675 SR-R 2024-2026, CFMOTO 675 SS 2024-2026, CFMOTO 675 NK 2025-2026 (with installation instructions)

Reshape Your Rear End: This for CFMOTO 675 SR tail tidy kit tucks the plate and lights up tight, giving the tail an instant shrink-wrapped look. From the side, the profile is sharp; from behind, it’s all sportbike aggression - no bodywork changes, just pure attitude.

One Big Light, Three Functions: A large integrated taillight handles it all: black ground, red brake, green running light, plus license plate illumination in one unit. The brake flashes bright, and the running light keeps you seen at night. Not a plug-and-play setup, but heat-shrink tubing and clear wiring instructions are included, so once properly spliced the connections stay waterproof and secure - rain or shine.

Aftermarket Signal Brackets: Pre-drilled brackets are ready for your custom turn signals. Note: these fit aftermarket signals only, not the original units.

Light, Stiff, Weather-Tough: Cut from a solid 3.0mm aluminum plate, this bracket stays vibration-free at speed - lighter than stock yet stiffer. The satin black powder coat bakes on hard, shrugging off rain, road grit, and pressure washers without fading or corroding, season after season.